What to do if the motor of my Braun Medical Equipment does not run?
If the motor of your Braun Medical Equipment does not run, it might be due to an oxidation film on the motor/battery connectors if the ACCULAN reamer is used infrequently. Try turning the drive shaft briefly by hand. Alternatively, the gear or bearing may be defective, requiring repair by the manufacturer.
Why is the motor of my Braun Aesculap Acculan Medical Equipment running too slowly?
If the motor of your Braun Medical Equipment runs too slowly or has too low a torque, the NiCd battery may be too weak or defective. Try changing the battery or checking the charger, and replace the battery if necessary.
What to do if Braun Medical Equipment motor runs but the tool does not turn?
If the motor of your Braun Medical Equipment runs but the tool doesn't turn, the gear changer may not be snapped in at the end position. Ensure the gear changer is snapped in at the end position.
Procedure for inserting the battery into the reamer, referencing Figures 1-3.
Procedure for removing the battery from the reamer, referencing Figure 4.
Instructions for operating the reamer with the Cement Injector GB 171 N.
Mechanism to prevent accidental activation of the reamer during use.
Guidelines for manual cleaning and disinfection of the ACCULAN reamer.
Instructions for routine care and inspection of the device for any damage.
Details on the validated steam sterilization procedures and parameters for the reamer.
Precautions to protect the battery and system from moisture.
General| Category | Medical Equipment |
|---|---|
| Power Source | Battery |
| Sterilization | Autoclavable |
| Manufacturer | Braun Aesculap |
| Material | Stainless Steel |
| Usage | Surgical |
To Next Page
