abusive, unreasonable use or supplemental damage. Defects that are the result of normal wear and
tear will not be considered manufacturing defects under this warranty.
What should I do if my thermometer is reading an Err message?
This will occur if the ambient temperature is not within the allowed operating range (50 – 104 °F or 10
– 40 °C.) In order to resolve this, we would recommend you allow the thermometer to remain for 30
minutes in a room where the temperature is between 50 and 104 °F or 10 and 40 °C.
What does a flashing display or no display mean when I turn on my thermometer?
A flashing display indicates a system error. We suggest waiting 1 minute until the thermometer turns
off by itself and then turns on again. If the problem persists, reset the thermometer by removing the
batteries momentarily.
How do I change the temperature scale from Celsius to Fahrenheit (or vice versa)
on my thermometer?
Press and hold the start button.
The Thermometer will turn on and show the start screen, where you will see all of the symbols on the
display.
Continue holding the button down, it will show C or F for one second and then change to say SET for
one second.
The pattern will continue as you hold down the start button. F → SET → C → SET
To select the option you want, release the activation/start button when the setting you want appears
on the screen.
How can I view the last temperature taken on my thermometer?
This model stores the last 9 temperature measurements. To display the stored measurement, the
thermometer must be turned on. Press the Mem button. The display shows the temperature, and when
releasing the Mem button, the stored temperature for that memory number is displayed, together with
“M”. Each time the Mem button is pushed, the stored reading and an M is displayed to indicate each
temperature measurement (e.g. M2). Memory mode is automatically exited by not pressing the
memory button for 5 seconds.
How do I store my thermometer?
Store thermometer and lens filters in a dry location free from dust and contamination and away from
direct sunlight. Always store the thermometer with the protective cap or with the cradle in place to
prevent dirt and scratches from damaging the device.
Do not store this thermometer in temperature extremes below -13 °F or over 131 °F or in excessive
humidity (above 95% relative humidity).
If thermometer is stored in a location that is cooler or warmer than where it will be used, allow it to
acclimate to the room temperature for 10 minutes before taking the measurement.
How do I use the Braun Lens Filter?
To avoid inaccurate measurements ALWAYS use this thermometer with a new, clean lens filter
attached.
If the thermometer is accidentally used without a lens filter attached, clean the lens.
The lens filter indicator will blink to signal one is needed.
To Next Page
Loading...
