Brauniger Competino - Altering a Route; Deleting a Route; Changing a Route into a Competition Route; The Competition Route

COMPETINO Manual
- 22 -
If you determine, for example, that WP4 must be changed, then you can select and delete it
(with F2) and insert a new one by pressing F1. Note: the marked WP before pressing F1
must be WP3. Again, the list of available WPs will appear with the prompt: Select Waypoint
No 4. After selecting and pressing Enter, the newly chosen one replaces the old waypoint.
If you want to delete a waypoint from the route, select it and press the F2 key (Del Wp.). The
WP is deleted from the list without any additional prompt.
6.11.2 Altering a Route :
You may select a route to be changed with the  or  keys and confirm with Enter. The
route name is changed first. If this is not what you want, then it is sufficient to press Enter
again in order to get to the waypoints. As described in the previous paragraph, an additional
WP can be added or deleted at this point.
6.11.3 Deleting a Route:
You may select the route to be deleted with the  or  keys and press F2 (Del Rte.). To
be on the safe side, the COMPETINO will prompt you once again: “Delete Route?” - to which
you may answer, “Yes” or “No”. However, it is not possible to delete the Competition-Route.
6.11.4 Changing a route into a Competition Route :
Call up Route (Main Setup Menu > Routes). With the  keys go to the desired route
and press Enter.
Now press The display asks “copy to Competition route?” confirm with “Yes”.
Please note: start cylinder, cylinder radii, and start time have to be set separately. Within this
procedure all radii are reset to the default values of 400m.
6.12 The Competition Route
In contrast to the routes described above, the Comp. Route has waypoints which are
mandatory and have to be reached. For example, turn points in a competition or on
competition performance flights. The regulation, which only recently came into effect in
documenting distances flown, replaces the detailed and often difficult to interpret
photographic documentation with photo sectors. And it is now totally dependent on the
recording of GPS receiver position data (tracklog points).
When flying Competition Routes, the pilot will be warned by an acoustic alarm when crossing
the circumference of a turnpoint cylinder or when entering / leaving the start cylinder at which
time the unit will automatically switch to the next WP. Besides the automatic switching to the
next WP, the pilot can manually change WPs with the ▲ or ▼ buttons; (Next or Prev. WP).
The Competition Route can be called up by prolonged pressing of the 0-I-II/Route key and
confirmed by pressing Enter (please refer to 6.13 to set and change routes). Here any of the
WPs can be defined to be the Start WP.
Any activated route remains active even after switch off of the instrument. It can only be
deactivated by prolonged pressing of the key and then pressing F2 Cancel route