All information herein is proprietary and confidential and may not be copied or reproduced without the expressed written consent of BRAY INTERNATIONAL, Inc.
The technical data herein is for general information only. Product suitability should be based solely upon customer’s detailed knowledge and experience with their
application.
Series 6A Installation, Operation & Maintenance – Safety
6A O & M : 3
Hazard-free use
This device left the factory in proper condition to be safely installed
and operated in a hazard-free manner. The notes and warnings in
this document must be observed by the user if this safe condition is
to be maintained and hazard-free operation of the device assured.
• Take all necessary precautions to prevent damage due to
rough handling, impact, or improper storage. Do not use
abrasive compounds to clean, or scrape its surfaces with
any objects.
• Configuration and calibration procedures are described
in this document. Proper configuration and calibration is
required for the safe operation.
• The control system in which the unit is installed must
have proper safeguards to prevent injury to personnel,
or damage to equipment, should failure of system
components occur.
• This document does not cover every detail about every
version of the product described. It cannot take into
account every potential occurrence in installation,
operation, maintenance and use.
• If situations transpire that are not documented in sufficient
detail, please request the required information from the
Bray Distributor or Representative responsible for your
area.
Qualified Personel
A qualified person in terms of this document is one who is familiar
with the installation, commissioning and operation of the device
and who has appropriate qualifications, such as:
• Is trained in the operation and maintenance of electric
equipment and systems in accordance with established
safety practices.
• Is trained or authorized to energize, de-energize, ground,
tag and lock electrical circuits and equipment in accordance
with established safety practices.
• Is trained in the proper use and care of personal protective
equipment (PPE) in accordance with established safety
practices.
• Is trained in first aid.
• In cases where the device is installed in a potentially
explosive (hazardous) location – is trained in the operation,
commissioning, operation and maintenance of equipment
in hazardous locations.
Storage
Bray Series 6A is not weatherproof until the unit is properly
installed, or all conduits and applicable port connections
are sealed off and prepared for storage. The units may be
shipped with temporary covers to prevent foreign matter
from entering through the conduit openings; however, the
user is responsible for replacing with the proper sealing plugs
to support its NEMA/IP ratings.
To prevent condensation from forming inside the unit,
maintain a near constant external temperature and store
indoors in a well ventilated, clean, dry room. The temperature
shall be between 40°F (4°C) and 85°F (29°C), with a relative
humidity less than 70%. Store units away from vibration
and direct sunlight exposure, and place units on a shelf or
wooden pallet in order to protect against dampness. Keep
units covered to protect against dust and dirt; if storing for
long term, placing the unit inside a plastic sealed bag may be
preferred.
Bray cannot accept responsibility for deterioration caused on-
site once the cover is removed or due to improper storage.
SAFETY INFORMATION - DEFINITION OF TERMS
indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
indicates a potentially hazardous situation which, if not avoided, may result in minor or
moderate injury.
NOTICE
used without the safety alert symbol indicates a potential situation which, if not avoided,
may result in an undesirable result or state, including property damage.
To Next Page
Loading...
Need help?
General
