B140 Counting Scale User Instructions 25
5 Configuration
5.1 Setting LED Brightness
Set the LED brightness by following these instructions:
1. In normal weighing mode, hold the ON/OFF and PLU1 keys at the same time
until …
SEtUP is displayed in the PIECE WEIGHT window.
LEd.brt (LEd brightness) is displayed in the COUNT window, and x
(x=1-3) is displayed in the WEIGHT window. This means that the LED
brightness is currently set to x.
2. Press the 1, 2 or 3 numerical key to change the brightness level (Default
setting: 2). Three is the brightest level. When the brightness you want is
displayed, press the Enter key to save the setting …
The scale will restart and returns to normal mode.
5.2 Setting the Auto-Off Timer
You can set an auto-off timer so that the scale will power down automatically after a
period of inactivity.
1. From normal mode, press and hold the ON/OFF and PLU2 keys at the same
time until the scale beeps …
SEtUP is displayed in the PIECE WEIGHT window.
A.oFF.t is displayed in the COUNT window.
The current value for the auto-off timer is displayed in the WEIGHT
window. You can choose from 0 to 30 minutes. If you pick 0, auto-off is
disabled and the scale will not power down automatically.
2. Key in the number of minutes of scale inactivity that will trigger the auto-off
function and press the Enter key to accept this value …
The scale will restart and return to normal mode.
To Next Page
Loading...
