Bresser 7003230 - Wireless Sensor Signal Receiving

27
4.3.14.1 DAILY AND SINCE MAX / MIN RECORDS
In normal mode, press [ MEM ] / [ MAX / MIN ] key to check the records of the on screen
reading in the following display sequence: daily MAX records
daily MIN records since
MAX records
since MIN records.
4.3.14.2 TO CLEAR THE MAX/MIN RECORDS
Press and hold [ MEM ] / [ MAX / MIN ] key for 2 seconds to reset all the MAX and MIN records.
4.3.15 MOON PHASE
The moon phase is determined by time
and date of the console. The following
table explains the moon phase icons of
the Northern and Southern Hemispheres.
Please refer to section 6.3 web interface
about how to setup for the Southern
Hemisphere.
Northern
Hemisphere
Moon Phase
Southern
Hemisphere
New Moon
Waxing Crescent
First quarter
Waxing Gibbous
Full Moon
Waning Gibbous
Third quarter
Waning
Crescent
4.3.16 SUNRISE / SUNSET & MOON RISE / MOON SET TIME
Sunrise / sunset time Moon rise / moon set time
The console indicates your location’s sunrise / sunset & moon rise / moon set times on the top
right corner of the display, which is based on time zone, latitude and longitude of your device
input in PWL.
4.3.17 WIRELESS SENSOR SIGNAL RECEIVING
1. The console display signal strength for the wireless sensor(s), as per table below:
No signal Weak signal Good signal
Outdoor 7-in-1 sensor
Hydro-thermal sensor channel
Other optional sensor
2. If the signal has discontinued and does not recover within 15 minutes, the signal icon will
disappear. The temperature and humidity will display “Er” for the corresponding channel.
3. If the signal does not recover within 48 hours, the “Er” display will become permanent. You
need to replace the batteries and then press [ SENSOR / WI-FI] key to pair up the sensor
again.