2 SAFETY
Read the installation instructions before connecting the chassis unit to the power source. Do not
install the chassis unit with power on.
The chassis or the portable unit is intended for installation in restricted access areas. A restricted
access area can be accessed only through the use of a special tool, lock and key, or other means of
security.
Blank face plates and cover panels serve three important functions: they prevent exposure to haz-
ardous voltages and currents inside the chassis, they provide electromagnetic interference shielding
and they direct the flow of cooling air through the chassis. Do not operate the chassis unit unless
all modules, face plates, front covers and rear covers are in place.
Only trained and qualified personnel should be allowed to install, replace or service this equipment.
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous.
If SFP modules are used ensure proper precautions are taken to protect eyes against harmful
infrared radiation. Do not look straight into the SFP module or fibers connected to the SFP module.
The SFP modules employed are certified in Laser Class 1.
Ultimate disposal of this product should be handled according to all national laws and regulations.
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
ambient temperature of 45 degrees Celsius.
Do not work on the system or connect or disconnect cables during periods of lightning activity.
VB440 Studio Probe User’s Manual v6.0 © Bridge Technologies Co AS 5
To Next Page
Loading...