19
No Load Voltage 255-273
No Load Frequency (RPM) 62.0 - 62.5 Hertz (3720 - 3750 RPM)
Starting Wattage 8,250 watts
Wattage* 5,500 watts
AC Load Current
at 120 Volts 45.8 Amps
at 240 Volts 22.9 Amps
Phase Single Phase
Rated Frequency 60 Hertz
Displacement 18.61 ci (305 cc)
Spark Plug Gap 0.030 in. (0.76 mm)
Fuel Capacity 7 U.S. gallons (26.5 L)
Oil Capacity 28 Ounces (0.83 Liters)
Resistance Values
Winding Resistance 030430-2
Rotor (at the slip rings) 24.3 - 29.1 Ohm
Power (wires 11-22 & 33-44) 0.19 - 0.24 / 0.19 - 0.24 Ohm
Excitation (wires 2-6) 1.26 - 1.50 Ohm
Power Ratings: The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of
Automotive Engineers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been
obtained and corrected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower
values are derived at 3600 RPM. Actual gross engine power will be lower and is affected by, among other things, ambient
operating conditions and engine-to-engine variability. Given both the wide array of products on which engines are placed and
the variety of environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross power
when used in a given piece of power equipment (actual "on-site" or net power). This difference is due to a variety of factors
including, but not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application
limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to
manufacturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series engine.
* This generator is rated in accordance with CSA (Canadian Standards Association) standard C22.2 No. 100-04 (motors and
generators).
Fastener Torque Values
Engine Adapter to Engine 200 lb-in. (23 Nm)
Alternator Adapter to Engine Adapter 200 lb-in. (23 Nm)
Rotor Bolt to Crankshaft 200 lb-in. (23 Nm)
Brushes to Rear Bearing Carrier 50 lb-in. (7 Nm)
Stator Bolt 80 lb-in. (9 Nm)
Generator Specifications
To Next Page
Loading...
