Briggs & Stratton E Series - Primer and Air Cleaner Systems

Page 6 of 12
Figure 6
Both the primer system and the ReadyStart® system have options for a foam element or paper cartridge air
cleaner. The primer systems are shown with foam element version (Figure 7a) and paper cartridge (Figure 7b).
Figure 7a Figure 7b
Install a new gasket in the carburetor flange and a new o-ring and ring retainer into the cylinder side of the venturi.
Assemble the air cleaner base to the carburetor and install two screws and tighten to the specification provided in
this APSI.
Rotate the carburetor to fit the governor link into the throttle lever, then insert the primer hose barb into the slot of
the mounting bracket, and then press the carburetor on the tube of the carburetor spacer. Secure the air cleaner
base to the mounting bracket with two screws and tighten to the specification provided in this APSI. Attach the
primer hose to the primer hose barb (paper cartridge version only).
Not for Reproduction