EasyManua.ls Logo

Briggs & Stratton Q6500 - User Manual

Briggs & Stratton Q6500
212 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Not for
Reproduction
Manual No. 80078802 Rev A
Q6500
(030796-00)
Copyright © 2019. Briggs & Stratton Corporation
Milwaukee, WI, USA. All rights reserved.
BRIGGSandSTRATTON.com
en - English
ar -



da - Dansk


es - Español

fi - Suomi
fr - Français

hu - Magyar



nl - Nederlands
no - Norsk
pl - Polski




sv - Svenska
sw - Kiswahili


Table of Contents

Questions and Answers

  • D
    Derek TaylorAug 4, 2025
    What to do if my Briggs & Stratton Q6500 engine will not start?
    • J
      jamie06Aug 4, 2025
      If your Briggs & Stratton Portable Generator engine won't start, runs rough, or shuts down, check the following: * Ensure the engine switch is in the ON (I) position. * Verify the oil level and fill the crankcase to the proper level, or place the generator on a level surface. * Make sure the fuel tank is full. * Confirm the spark plug wire is connected to the spark plug. * If flooded with fuel, wait 5 minutes before re-cranking the engine.
  • M
    maria52Aug 15, 2025
    Why is my Briggs & Stratton Q6500 Portable Generator running but has no AC output?
    • T
      Tara MartinAug 15, 2025
      If your Briggs & Stratton Portable Generator engine is running but there's no AC output, it could be due to several reasons: * The generator may be overloaded or overheated. Remove some loads and press the OVERLOAD RESET button on the control panel. * There might be a poor connection or a defective cord set. Check and repair as necessary. * The connected device could be faulty. Try connecting another device that is in good condition.
  • P
    patrick56Aug 25, 2025
    What to do if my Briggs & Stratton Q6500 Portable Generator bogs down under load?
    • M
      Michael JohnsonAug 25, 2025
      If your Briggs & Stratton Portable Generator engine runs well without a load but bogs down when loads are connected, the generator is likely overloaded. Remove some of the loads from the generator.

Summary

Safety and Control Symbols

Equipment Description

Generator Operation

Safe Location for Operation

Details safe placement of the generator outdoors, away from structures and vegetation.

Carbon Monoxide Poisoning Prevention

Advises on outdoor use, exhaust direction, and CO alarms.

Oil and Fuel Recommendations

Details recommended oil types, viscosity, and fuel requirements.

Generator Start-up Procedure

Step-by-step instructions for starting the generator engine.

Connecting Electrical Loads

Guides on connecting loads via transfer switch or extension cords.

Generator Output Receptacles

Overload Reset Function

Generator Shut Down Procedure

Step-by-step instructions for safely turning off the generator.

Maintenance

Maintenance Schedule

Engine Maintenance Details

Spark Plug Service

Generator Storage Guidelines

Fuel System Protection for Storage

Troubleshooting Common Issues

No AC Output

Addresses issues when the engine runs but no AC power is available.

Engine Bogs Down Under Load

Troubleshoots why the engine runs at no-load but struggles with connected loads.

Engine Start or Running Problems

Covers issues like engine not starting, rough running, or shutting down.

Briggs & Stratton Products Warranty Policy

Limited Warranty

About Your Warranty

Briggs & Stratton Q6500 Specifications

General IconGeneral
Running Watts5000W
Starting Watts6500W
Engine Displacement306cc
Fuel Tank Capacity5 gallons
Weight128 lbs
Run Time at 25% Load14 hours
InverterYes
EngineBriggs & Stratton OHV
Voltage120/240V
WheelsYes
Run Time14 hours at 25% load
Noise Level at 23 feet66 dBA
Noise Level66 dB(A)
Outlet Types4 x 120V 20A, 1 x 120/240V 30A

Related product manuals