PROGRAM & OPERATION GUIDE
IMPORTANT: NOW THAT THE DIGITAL DEADBOLT IS INSTALLED, YOU MUST COMPLETE STEP 10
BEFORE THE ELECTRONIC FEATURES OF THIS PRODUCT WILL WORK. ALL PROGRAMMING
MUST BE DONE WITH THE BOLT RETRACTED. LEAVE THE DOOR OPEN WHILE PROGRAMMING TO
PREVENT ACCIDENTAL LOCKOUT. READ THE PROGRAMMING BASICS BELOW BEFORE
PROCEEDING TO STEP 10.
The default PC is 0000. (For better security, please change it after completing Step 10.)
Programming Code (PC)
a.
The PC is the administrative code for entering lock functions. It does not operate the lock.
b.
The default UC is 1234. (For better security, please delete it after completing Step 10.)
User Code (UC)
a.
Up to 6 User Codes can be stored.
b.
A UC is used to unlock the deadbolt.
c.
All programming (entering functions) has to be done with the deadbolt unlocked.
Programming Basics
a.
All functions begin with entering the Programming Code.
b.
During a programming sequence, the Programming Button turns orange to indicate that you can
proceed. See the Visual and Audio Feedback Signals table for more indicators.
e.
The Programming Button is used to enter data.
c.
Each step of a function programming sequence needs to be completed within 6 seconds.
d.
Enter this sequence on the keypad:
(The PC will always be 0000 for this step.)
a.
You will hear the motor run and then 2 beeps and the button will ash green twice.
b.
!!! NOTE: Always run this step on rst installation or after a default setting
restoration. The motor will not operate and no other programming
function can be entered before completing this step.
Detect Left/Right Hand Door Installation
10
0
ENTER PC
8
To Next Page
Loading...
