BRINKS BHS 2000A - Panel Options and Reporting; Panel Options Locations 184-185; Reporting Options Settings

PANEL OPTIONS 1 LOCATION 184
Bypass after download (8) - If enabled, zones which are violated after & downloading Session will be
bypassed.
Zone 9-16 Enable (4) - If selected, the ZIB-8 zone expander can be used.
Power Up armed aftet* download (2) - If enabled, Unit will arm after a downloading sequence.
Silent Burglar Alarm (1) -If selected, burglar alarms do not sound the speaker/bell.
PANEL OPTIONS 2 LOCATION 185
Quick Arm Enable (8) - If selected, pressing the ON button on the SCS will arm the panel.
Defer test message (4) - If selected, a programmed automatic test message will not be transmitted if any
other report is transmitted within each Test Interval period.
Abort enable (2) - If selected, pending reports are canceled by disarming the panel.
Phone 2 backup (1) - If selected, phone #2 is used only if the communicator fails to report to the central
station using phone #1.
REPORTING OPTIONS
Low Battery restoral = Phone enable is programmed in location 089.
Low Battery report = Phone enable is programmed in location 091.
AC Restoral = Phone enable is programmed in location 093.
AC Loss = Phone enable is programmed in location 095.
Reset Report = Phone enable is programmed in location 099.
Auto Test = Phone enable is programmed in location 101.
Manual Test = Phone eH4ble is programmed in location 103.
Cancel = Phone enable is programmed in location 107.
24