BRINKS BHS 2000A - Zone and Panel Options; Zone Options Locations 157-159; Panel Options Location 183

ZONE OPTIONS LOCATION 157
3"Plgit option (8) - If enabled, The control panel can be armed and disarmed using a three digit access
Jf not enabled, the unit will operate on a 4 digit code.
Wr*P ground option (4) - If enabled, the unit will operate on the last three or four digits entered. If pot
gpihled, the control panel will only operate if the three or four digits consecutively entered are correct.
New 3QQ0A PCB (2)- If disabled, BHS-2000A Microprocessor will operate on older BHS-1000B and
PHS-100QC control panels and can now use the DCU-6Q2B LCD keypad.
JJ/p violation Warning (1) - If enabled, the unit will perform as follows: If any E/E ?one is in a violated
ggntiition at the expiration of the Exit time interval, then the Entry delay time will be aborted (e g ) go to
Zero); hence immediately initiating the dialer delay sequence (low pulsed tone from the speaker is
emitted); or immediately going into alarm if no dialer delay was programmed. If not enabled, the unit will
go into a normal prealarm and alarm state if the E/E zone is violated at the expiration of the Exit time.
ZONE OPTIONS LOCATION 158
Call Brinks Flag (2) - If enabled, the "Call 800. .." segment lights on the keypad. Primarily used by
prism Downloading software.
p| panel Bit (1) - If enabled, all functions on the panel are disabled. Keypad will display not ready and
the call Brinks # will appear. Only the fire zone will respond locally.
LOCATION 159
Zone Expander (2) - If enabled, Zones 9-16 are available if a ZIB-8 is installed
Keypad Exit Tone (1) - If enabled, keypad emits a tone during the exit time.
PANEL OPTIONS 0 LOCATION 183
false alarm Prev. (8)- Panel shuts down if AC is off and DC power drops below 10.2 VDC.
force nomad (4)- Allows ACP to arm when nomad types are violated.
No EOLR (2) - If selected, Burglary zones do not require EOLR termination. Not to be used for UL
installations.
Strobe (1)- If selected, Bell output stay on after siren times out. Strobe is then turned off when unit is
disarmed.
23