BRINKS BHS-3000A - Turning the System on When It Is Not Ready

11
Turning the System On When It Is Not Ready
If the system is not ready to turn on, you get a not ready message. This
message could mean, for example, that one of the protected windows in
your house is open. If you have a Standard Keypad, the READY light is
off. If you have a Premium Keypad, the message window reads NOT
READY.
If you press the ON key when the system is not ready to turn on, the
keypad sounds an error tone and the system does not turn on.
To make the system ready to arm and it on, do the following:
1. Press the OPTONS
key.
2. Press the 7 key.
3. Observe which zone
light blinks for the
next five seconds.
This is the zone that
needs to be
corrected before the
system will turn on.
(There may be
more than one.)
1. Observe the number
displayed in the
message window.
This is the zone that
needs to be corrected
before the system will
turn on. (There may
be more than one, if
so, the numbers are
shown one at a time.)
4. Refer to the Pop-Up
Zone Card to verify
the zone’s location.
2. Refer to the Pop-Up
Zone Card to verify
the zone’s location.
5. If the zone is a door
or window, make
sure that it is
securely closed.
3. If the zone is a door
or window, make
sure that it is securely
closed.
6. If the READY light
illuminates, turn the
system on.
READ
Y
4. If the message
window reads
READY, turn the
system on.
(continued)