9
CLEANING AND MAINTENANCE
Use the Self-Cleaning Ozone Feature
It is highly recommended that you use the self-cleaning feature on a weekly basis to sanitize tanks
and water lines.
To activate the self-cleaning cycle, press in the
self-cleaning switch (14), hold for 5 seconds, and
release.
The power indicator light on the front of the
dispenser will begin blinking, indicating the
cleaning process is underway.
During the cleaning cycle, ozone is produced and injected into the water system. This ozone kills
bacteria and biolms typically found in water dispensers. By the time the cleaning cycle ends, the
ozone is converted to harmless oxygen and emitted into the air.
IMPORTANT: The cycle takes 90 minutes to complete. During this time do not dispense and
drink the water. Doing so may result in an odd taste. For your convenience, we
recommend that you do this during a period when the dispenser is not in use,
such as overnight hours or when staff is away from the ofce. During the cycle
you may smell a faint trace of ozone.
Care and Maintenance
• Keep this dispenser in a dry and cool place and avoid direct sunshine.
• Ensure the back of the dispenser is at least 20 cm (8 in.) away from the wall.
• Never put the dispenser on paper or foam, which may store water and then cause creepage.
Never put anything ammable beside this machine.
• Do not use the dispenser outdoors or in a place that can be splashed by water.
• If the dispenser is not in use for longer than a 24-hour period, turn off the heating switch or the
refrigerating switch to save power and drain any remaining water.
• Clean your cabinet, controls, bottle probe and spout each time you change your water bottle.
Use a clean soft cloth and a food grade sanitizer or bleach.
• Empty and clean the drip tray, grid and oat as needed.
14
To Next Page
Loading...
Need help?
General
