Brita VIVREAU EXTRA Series - Page 9

EN | 5352 | EN
USING THE DEVICE USING THE DEVICE
Dispensing water Errors and Warnings
The undercounter display (11) will
show information and solutions:
• Empty drainage system
Drip tray or waste water container
is full
• Replace CO
2
bottle
CO
2
bottle is empty or CO
2
pres-
sure is low
• Call service
Please call customer service (see
rear page)
For further information about the
warnings and errors please refer to
the chapter ‘Troubleshooting’ see
page 28. If the problem persists,
please contact customer service (see
rear page).
The display of the undercounter unit
enters standby mode when not in
use for more than 5 minutes (default
setting).
To activate the display, touch any-
where on the display. The display
will awake automatically.
If the display does not wake up
please call customer service (see
rear page).
The timer for the standby mode
can be adjusted in the menu by the
operator or a service technician (see
rear page).
Display standby
On the tap display:
Error: Look at the under-
counter display (11) for
further details.
Dispensing hot water:
1. Set a vessel suitable for hot
liquids under the tap outlet.
2. Touch hot water buttons one af-
ter another (rst left, then right)
within 3 seconds.
3. Release the button to stop dis-
pensing hot water.
Warning:
Risk of scaling due to hot
water. Keep extremities away from
tap outlet.
Caution:
Don’t touch the tap outlet.
Danger to health due to lack of
hygiene!
With preset portions:
1. Press BRITA button on the
display.
2a. Press BRITA button once to acti-
vate the glass portion size.
2b. Press BRITA button twice to
activate bottle portion size.
3. Press the button of the desired
water type only once briey.
Dispensing will stop automatically
when the preset quantity has been
reached.
Pressing any water type button will
stop dispensing immediately.
Note: Portion setting is not available
for hot water.
1.1.
On the undercounter display:
1
2
4
5
I. VIVREAU Extra Tap System
8
7
6
12
13
3
A B C D
10
9
11