Brita VIVREAU EXTRA Series - Page 8

EN | 5150 | EN
USING THE DEVICE
The installation and initial commis-
sioning must be carried out exclu-
sively by the manufacturer or by a
qualied person.
Please contact customer service for
more information (see rear page).
1. Set a suitable vessel under the
outlet.
2. Dispense the desired water type by
pressing the respective button.
3. Press button until the desired
amount of water is dispensed.
Make sure not to overll the
vessel.
The On/Off switch (7) is to be found
at the front of the of the cooler/
cooler-carbonator (6) at the water
dispenser undercounter unit.
Set switch (7) to position I to
switch on.
Set switch (7) to position O to
switch off.
The boiler is not equipped with a
separate switch. It is activated or
deactivated by the cooler/cooler-car-
bonator.
Startup On/Off Dispensing water
Caution:
After 72 hours of nonuse, rinse
the water dispenser thoroughly (see
‘Period of inactivity’ on page 64).
Caution:
Ensure that the device has
been standing upright for 24 hours
before starting up! Danger of damage
to cooling system!
Caution:
The water dispenser has to
be installed in locations which have
free access and can be monitored by
trained personnel.
Please observe the foldout page!
Note: A safety feature interrupts
the dispense after 90 seconds of
continuous dispense (Exception hot
water: after 60 seconds). Release
and press button again to continue
dispensing.
Note: Depending on the selected
performance option, the system
may not include all 5 water types. In
general, the C-Shape is able to pro-
vide all 5 water types. The I-Shape
is principally not able to provide hot
water, only the 4 cold water types.
C-Shape:
I-Shape:
Chilled still:
Chilled still water
Chilled semi-sparkling:
Moderately carbonated
sparkling water
Chilled sparkling:
Strongly carbonated
sparkling water
Unchilled still:
Unchilled still water
Hot:
Hot water
1.1.
2.2.
1.1.
2.2.
2.2.
2.2.
1.1.
1.1.
1
2
4
5
I. VIVREAU Extra Tap System
8
7
6
12
13
3
A B C D
10
9
11