12
Before You Install
Adjusting the Recline
Angle
• To adjust the recline angle of
the base, hold in the recline
adjustment button on the recline
adjustment foot and move the foot
up or down.
• Correct recline angle is achieved
when the green markers on
the recline angle indicators are
visible between the two lines (see
next page).
• If there is a problem achieving
the appropriate recline angle after
following the previous steps:
* Try another approved seating
position in your vehicle
* Uninstall the base and lower
the recline angle adjustment
foot to the lowest position.
* Remove the base from the
vehicle.
* Place a rolled towel or pool
noodle in the vehicle seat
bight.
* Place the base on the towel(s)
or pool noodle(s) to achieve
the appropriate recline angle
for the base.
NOTE: If towel(s) or pool noodle(s) is
needed to achieve appropriate recline
angle, the recline angle adjustment
foot on the base should remain in its
lowest position.
Installing with Base
To Next Page
Loading...
