14
LCS Installation
• Verify that your vehicle is
equipped with lower anchors.
• Remove lower connectors
from the storage slots on the
base by pressing the red
button and pulling outward.
• Press and hold the lower
connector adjuster release
button and pull to lengthen the
strap.
Installing with Base
• Only raise the base as described in these instructions.
Do not use anything to raise the base of the infant car
seat off the front edge of the vehicle seat. In a crash,
this could cause the infant car seat not to perform as
intended.
• For LCS installation, the base must be secured in the
vehicle before attaching the occupied infant car seat.
• Use either the LCS or a vehicle belt methods to install
this child seat. Using both is not approved and may
cause the child seat not to perform as intended.
To Next Page
Loading...
