27
• Push the infant car seat firmly
into the vehicle seat while
removing all slack from the
vehicle belt.
• Adjust the infant car seat
handle to any locked position.
• Verify that all connections are secure. Check that:
* The vehicle belt is not twisted.
* The vehicle belt is tight and locked.
* The recline level line on the shell label is level to the ground.
* The infant car seat handle is rotated into any locked position.
* The infant car seat is secure and it moves less than 2.5 cm (1 in.)
front-to-back or side-to-side at the vehicle belt path.
* Check the recline angle. The proper recline angle is achieved when
the recline angle line on the car seat is level to the ground.
Installing without Base
To Next Page
Loading...
