Britax Elite - Installing the Elite in the car; Fitting the Elite using a lap and diagonal seat-belt

- 10 -
Installing the Elite in the car
Fitting the Elite using a lap and diagonal seat-belt
Place the Elite forward facing on the
passenger seat. Then tighten the
harness by pulling the adjuster strap.
1
Pull the seat-belt fully out and hold
the lap and the diagonal sections
together. Keep them together as you
pass the seat-belt from the front of the
seat through the first seat-belt routing
slot, indicated by the red arrow on
your Elite ...
2
REMEMBER - Always make sure that the cover is properly zipped up before
fitting your child seat into your car.
... and then pass the seat-belt back
through the second seat-belt routing
slot to the front of the seat.
3
Pull all the slack from the seat-belt to
the front of the Elite and fasten the
seat-belt. Make sure the seat-belt is
not twisted.
4