Britax Elite - How to change the height of the shoulder straps

- 6 -
Always check the height of the shoulder straps before you install your child seat in a
car.
Place your child in the seat and buckle up the harness. The shoulder straps MUST
be threaded through the slots in the cover and shell nearest the top of your child’s
shoulders. If in any doubt always use the slot above the shoulder rather than below it.
NO - Too highNO - Too high
NO - Too highNO - Too high
NO - Too high
NO - NO -
NO - NO -
NO - Too low
YES - CorrectYES - Correct
YES - CorrectYES - Correct
YES - Correct
4
Undo the studs on the back of the
head support and remove it from your
Elite. Loosen the harness by pushing
down the adjuster button as you pull
the shoulder straps forward as much as
possible.
1
Unzip the cover at the back. Unhook
one shoulder strap and pull it through
to the front of your car seat.
2
How to change the height of the shoulder straps