Britax Elite - Fitting your child in the Elite; Releasing your child from the Elite

- 13 -
Fitting your child in the Elite
Loosen the harness by pushing the
adjuster button down as you pull the
shoulder straps forward as much as
possible.
1
Unfasten the buckle by pressing the
red button (a) and place your child in
the seat. Fit the harness around your
child and fasten the buckle up (b).
2
Check that the harness is not twisted
and pull the shoulder straps up to
tighten the lap section of the harness.
3
Then tighten the harness by pulling
the adjuster strap forward, making
sure the harness is a comfortable but
FIRM fit around your child.
Finally ensure that the chest pads are
pulled down on to the child’s chest
IMPORTANT - Ensure that the
lap section of the harness is low
down on the child’s body and
in contact with the pelvis.
4
To release your child from the Elite, simply undo the harness.
Releasing your child from the Elite
Click!Click!
Click!Click!
Click!
(b)(b)
(b)(b)
(b)
(a)(a)
(a)(a)
(a)