Britax FRONTIER - Using the Versa-Tether

13
Locate the LATCH anchors in your 2
vehicle.
Verify that the LATCH connector
3
is right-side up and that the
LATCH strap is not twisted before
connecting.
NOTE: The LATCH connectors will click when properly attached.
IMPORTANT: Refer to your vehicle owner’s manual or contact the vehicle
manufacturer for the maximum weight rating for their LATCH anchors.
Use the vehicle belt (not LATCH) for installations with children who weigh
more than the vehicle LATCH anchor limit. Unless specified otherwise by
the vehicle manufacturer, assume a 40 pound (18.1 kg.) child is the vehicle
LATCH anchor limit. Only use the vehicle’s designated tether anchor for the
chosen seating position.
Using the Versa-Tether
WARNING:
Attach the Versa-Tether only to tether anchors identified by your vehicle •
manufacturer as tether anchorage points.
If your vehicle does not currently have a tether anchor attachment, refer to your •
vehicle owner’s manual or contact your vehicle man u fac tur er for assistance. DO
NOT modify your vehicle without advice from your vehicle manufacturer.
When using the child seat in harness mode:
Britax recommends that the tether be used at all times when installing the child •
seat. Using the tether will improve the stability of your child seat and reduce
the risk of injury.
Always use the Versa-Tether for children weighing 65 – 80 lbs (29.5 – 36.3 kg). •
IMPORTANT: You must use the Versa-Tether if installing the child seat
using the LATCH connectors.
Child Seat features Overview
Top