31
Harness Mode
Pull the vehicle belt out and route 5
the belt through the first belt slot,
under the cover and through the
second belt slot.
Verify that the belt is not twisted 6
and buckle.
Push the child seat firmly into 7
the vehicle seat while pulling the
lap belt through the belt slot to
remove all slack.
Ensure that the vehicle belt *
is locked as directed by your
vehicle owner’s manual.
Attach and tighten the Versa-
8
Tether.
IMPORTANT: Ensure any excess
Versa-Tether
®
webbing is contained
within your vehicle.
Verify that the vehicle belt is tight and the child seat is secure.
9
The child seat is secure when it cannot be moved front-to-back or *
side-to-side more than 1” (2.5 cm.) at the belt path. If the child
seat is not secure, repeat the installation procedure or use a different
seating location.
Harness Mode: Installing Your Child Seat
To Next Page
Loading...
