EasyManua.ls Logo

Britax King - 3.1 Installing the Child Safety Seat

Britax King
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3.1 Montage du siège auto
Comment fixer votre siège auto au
moyen de la ceinture à 3 points de
votre voiture :
Þ Placezla coque du siège 11 en
position d'assise verticale (voir 5.).
Astuce ! Le siège ne peut être
ouvert qu'en position verticale.
Þ Placez sur le siège auto sur le siège
du véhicule en l'orientant vers la
route.
Þ Poussez le levier de déverrouillage
gris 1 vers le haut et tirez
simultanément sur le milieu du
bord supérieur de la coque.
La coque 11 se désenclenche.
Þ Basculez la coque 11 vers l’avant
jusqu'à ce qu'elle s'enclenche
correctement.
Þ Sortez la ceinture en tirant et
passez-la entre la coque 11 et la
partie inférieure du siège 12.
Þ Enclenchez la languette dans le
fermoir de la ceinture 2 du véhicule.
CLIC !
Þ Introduisez la sangle ventrale 3
dans les guidages de sangle rouge
vif 4 situés des deux côtés de la
partie inférieure du siège 12.
Attention ! Ne pas torsader la
sangle.
Þ Passez la sangle diagonale 5 au-
dessus du crochet de sangle 9.
3.1 Installing the child
safety seat
To secure the child seat using the
3-point belt of your vehicle proceed
as follows:
Þ Adjust the seat shell 11 to the
upright seating position (see 5.).
Note: The seat can only be opened
in the upright position.
Þ Place the child safety seat facing
forward on the vehicle seat (in the
direction of travel).
Þ Pull up on the grey release lever 1
and at the same time pull at the top
in the centre of the edge of the
seat shell.
The seat shell 11 disengages.
Þ Tip the seat shell 11 forward until it
latches.
Þ Pull out the vehicle seat belt and
place it between the seat shell 11
and the seat base 12.
Þ Engage the buckle tongue in the
vehicle seat buckle 2 with an
audible
CLICK!
Þ Place the lap belt section 3 in the
light red belt guides 4 on both sides
of the seat base 12.
Caution! Do not twist the belt.
Þ Guide the diagonal seat belt section
5 over the top of the belt hook 9.
3.1 Einbau des Auto-
Kindersitzes
So sichern Sie Ihren Kindersitz mit
dem 3-Punkt-Gurt Ihres Fahrzeugs:
Þ Verstellen Sie die Sitzschale 11 in
die aufrechte Sitzposition (siehe 5.).
Tipp! Der Sitz lässt sich nur in der
aufrechten Position öffnen.
Þ Stellen Sie den Auto-Kindersitz in
Fahrtrichtung auf den Autositz.
Þ Drücken Sie den grauen
Entriegelungs-Hebel 1 nach oben
und ziehen Sie gleichzeitig oben in
der Mitte am Sitzschalen-Rand.
Die Sitzschale 11 rastet aus.
Þ Kippen Sie die Sitzschale 11 nach
vorn bis sie festhakt.
Þ Ziehen Sie den Autogurt heraus
und führen Sie ihn zwischen der
Sitzschale 11 und dem Sitzunterteil
12 durch.
Þ Rasten Sie die Schlosszunge im
Auto-Gurtschloss 2 ein.
KLICK!
Þ Legen Sie den Beckengurt 3 in die
hellroten Gurtführungen 4 an
beiden Seiten des Sitzunterteiles
12.
Vorsicht! Gurt nicht verdrehen.
Þ Führen Sie den Diagonalgurt 5
oberhalb des Gurthakens 9 vorbei.

Table of Contents

Related product manuals