EasyManua.ls Logo

Britax Roundabout 55 - Child Seat Functions; Adjusting the Harness Height

Britax Roundabout 55
86 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
Adjusting the Harness Height
NOTE:
In rear-facing mode,
always position the harness straps
at or below your child’s shoulders.
See page 5.
In forward-facing mode, always
position the harness straps at or
above your child’s shoulders. See
page 5.
1 Loosen the harness.
a Lift harness adjuster lever
b Pull both harness straps forward
2 Unhook both harness straps
from the yoke.
3 Pull one harness strap through
the shell and cover to the front
of the child seat.
4 Feed the harness strap through
the desired harness slot in the
cover and shell to the back of
the child seat.
Repeat steps 3 and 4 for
second harness strap.
5 Nest the harness straps by
inserting the right strap loop
into the left strap loop.
6 Before reattaching the harness
straps to the yoke, hold the
harness yoke as shown, and
ensure that the adjuster strap
attached to the yoke is not
twisted.
7 Slide nested harness straps
completely onto the harness
yoke.
Child Seat Functions
1b
1a
Adjuster
Strap

Table of Contents