20
Install with the LUAS as shown above.
Before You Begin:
Check that your vehicle has lower anchors.
* Refer to your vehicle owner’s manual or contact the vehicle
manufacturer for the maximum weight rating for their lower
anchors. Use vehicle belt (not lower connectors) for installations
with children who weigh more than the vehicle lower anchor limit.
Unless specified otherwise by the vehicle manufacturer, assume
a 18.1 kg (40 pound) child is the vehicle lower anchor limit.
Remove the lower connectors from the storage slots in the
base. Press the adjuster release button and pull the strap to full
length. Repeat for the second strap.
Recline this child seat to position 3 and place rear-facing on the
vehicle seat (see page 15).
* When properly installed in the rear-facing
position, the back angle of the child seat
VKRXOG EH DW OHDVW Ý IRU FKLOGUHQ DQG XS
WR Ý IURP YHUWLFDO IRU LQIDQWV XQDEOH WR
maintain head and neck control (not to
H[FHHG Ý ZKHQ WKH FDU LV SDUNHG RQ D
level surface. Use the blue line as a guide
to achieve the proper recline angle for rear-
facing installations. The blue line will be parallel to the ground
when the child seat angle is at the center of the angle range
²Ý,IQHFHVVDU\WKHSURSHUUHFOLQHDQJOHFDQEHDFKLHYHG
by placing a rolled towel or pool noodle in the vehicle seat bight.
Britax recommends that the Versa-Tether is used at all times.
Using the tether will improve the stability of the child seat and
reduce the risk of injury. Check your vehicle owner’s manual
for tether anchor locations. See page 18 for possible rear-facing
tether configurations.
LUAS Installation
Rear-Facing Installation
To Next Page
Loading...
