Britax Roundabout 55 - Infant Body Pillow; Recline Positions

15
Infant Body Pillow
The infant body pillow is designed
to provide better fit and comfort for
infants using this child seat. Fold the
flaps in for additional side support.
NOTE: Remove the infant body pillow
after the child can sit comfortably in the
child seat without additional support.
Recline Positions
This child seat has 3 positions. To adjust, pull the recline handle then rotate
the child seat shell into the desired position. Release the recline handle,
then verify the child seat has locked into position.
NOTE: Set the recline position BEFORE installing.
Position 1
Position 2 Position 3
Rear-Facing
When installed in the rear-facing position, the child
VHDWVKRXOGEHUHFOLQHGDWOHDVWÝIURPYHUWLFDOIRU
FKLOGUHQDQGXSWRÝIURPYHUWLFDOIRULQIDQWVXQDEOH
to maintain head and neck control (not to exceed
ÝZKHQWKHFDULVSDUNHGRQDOHYHOVXUIDFH:KHQ
installing the seat in rear-facing mode, recline the
seat to position 3 and use the guide line on the child
seat to help achieve an acceptable recline angle for
rear-facing installations.
Forward-Facing
IMPORTANT: In forward-facing installations, it is important that the base of
the child seat rests completely flat on the vehicle seat. As illustrated below,
it is permissible to allow up to 20% or 7.6 cm (3 inches) of the base to hang
over the edge of the vehicle seat. Some vehicle seats do not allow enough
of the child seat base to contact the vehicle seat. If this is the case, adjust
the recline angle to a more upright position. Not doing so could cause the
child seat not to perform as intended.
Acceptable overhang Unacceptable overhang
Child Seat Functions
90°
0°
90°
0°
90°
0°
UP TO 7.6 cm
OF OVERHANG
ACCEPTABLE
OVER 7.6 cm
OF OVERHANG
NOT ACCEPTABLE