ACS300 Power Specifications
Mounting
Mount the box directly to drywall using the four outer corner screw mounting holes (red
below) (or two alternate positions) (blue below) on the back of the ACS300 enclosure.
Additionally, the installer can remove the printed circuit board (PCB) and mount the ACS300
enclosure directly to a 4” square electrical junction box (green below).
Wiring can enter through the back of the ACS300 enclosure through the drywall, or wiring
can come up through the bottom opening of the ACS300 enclosure in front of the drywall or
mounting backboard.
ACS300 Panel Light Indicators
Upgrade Firmware
Before proceeding with any installation, contact Brivo Technical Support
at 866-274-8648 or email customercare@brivo.com to upload the latest
firmware onto your ACS300. Follow all instructions provided by Brivo
Technical Support during the upgrade process.
Note: To silence the tamper
alarm during installation, flip the
Tamper Switch to Disabled in
the System Switch Bank (see the
System Switch Settings diagram
to the right).
To Next Page
Need help?
General
