Brocade Communications Systems 8 - Page 248

216 Fabric OS Command Reference
53-1001764-02
dlsSet
2
switch:admin> dlssshow
DLS is set by default with current routing policy
DLS configuration commands on a switch with a port-based policy:
switch:admin> dlsshow
DLS is set by default with current routing policy
DLS is set with Lossless enabled
switch:admin> dlsreset
DLS is not set
switch:admin> dlsshow
DLS is not set
switch:admin> dlsset --enable -lossless
DLS and Lossless are set
switch:admin> dlsshow
DLS is set with Lossless enabled
switch:admin> dlsset
Lossless is set (unchanged)
switch:admin> dlsset --disable -lossless
Lossless is not set
switch:admin> dlssshow
DLS is not set
To attempt to enable Lossless while XISL use is enabled:
switch:admin> dlsset --enable -lossless
Lossless option cannot be enabled when XISL use is allowed.
Please disable the switch with 'switchdisable' and run 'configure' to disallow
XISL use before enabling Lossless.
See Also aptPolicy, dlsReset, dlsShow, iodReset, iodSet, iodShow, uRouteShow, topologyShow