Fabric OS Command Reference 241
53-1001764-02
fanDisable
2
fanDisable
Disables a fan unit.
Synopsis fandisable unit
Description Use this command to disable a nonfaulty fan unit by setting the RPM speed to 0.
Notes This command is not available on nonbladed systems except for the Brocade 4100, 4900, and
5300.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operand:
unit Specifies the number of the fan unit to disable.
Examples To disable a fan unit:
switch:admin> fandisable 1
Fan unit 1 has been disabled
See Also fanEnable, fanShow
To Next Page
