Fabric OS Command Reference 945
53-1001764-02
switchViolation
2
switchViolation
Dumps the DCC violations for a switch.
Synopsis switchViolation --dump -dcc
Description Use this command to display all Device Connection Control (DCC) violations that have occurred on
a switch. Internally the command searches "errdumpall" for the DCC violations. For each DCC
violation, the command displays the device WWN and the port where the violation occurred.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS Commands" and Appendix A, "Command
Availability" for details.
This command can be executed on both active and standby CPs. This command does not support
High Availability (HA).
Operands This command has the following operands. If executed without operands, the command prints the
usage.
--dump Displays specified policy violation.
-dcc Specifies the violation type as DCC.
Examples To display DCC violations for a switch:
switch:admin> switchviolation --dump -dcc
Device WWN Port
-----------------------------------
22:00:00:04:cf:75:59:87 10
See Also none
To Next Page
