Brocade Communications Systems 8 - Page 263

Fabric OS Command Reference 231
53-1001764-02
fabPortShow
2
Operands This command has the following operands:
slot For bladed systems only, specifies the slot number of the port to display,
followed by a slash (/).
port Specifies the port number to display, relative to its slot for bladed systems.
Use switchShow to list valid ports.
Examples To display fabric port information:
switch:admin> fabportshow 4/14
Fabric Port Information:
========================
Port: 62
State: P3
List: 0x10068418
List Count: 0
Flags: 0x280120
nbrWWN: 10:00:00:60:69:80:06:cf
nbrPort: 5
lr_tid: 0x1005dbd8, IDLE STATE
flow_control:1
nghbr_esc:
etiz_state: -1 (Unknown ETIZ state)
red_ports:
10 11 62 63
Open commands pending:
======================
No commands pending
See Also portShow