556 Fabric OS Command Reference
53-1001764-02
perfAddEEMonitor
2
SourceID Specifies the 3-byte SID (Source ID) of the originator device. It should be in
"0xDDAAPP" format, where DD is domain ID, AA is area ID and PP is AL_PA ID.
For example, 0x050200 has a domain ID of 5, an area ID of 2, and an AL_PA
ID of 0. SourceID and DestID both cannot be 0x000000.
DestID Specifies the 3-byte DID (destination ID) of the destination device. It should
be in "0xDDAAPP" format, where DD is domain ID, AA is area ID and PP is
AL_PA ID. For example, 0x050200 has a domain ID of 5, an area ID of 2, and
an AL_PA ID of 0. SourceID and DestID both cannot be 0x000000.
Examples To add an end-to-end monitor to blade 1 port 2:
switch:admin> perfaddeemonitor 1/2 "0x050200" "0x1182ef"
End-to-End monitor number 0 added.
To add an end-to-end monitor to an Encryption switch:
In this scenario, one target disk storage device connects to the Encryption switch, and an initiator
device connects to a DCX backbone. The DCX is directly connected to the Encryption Switch. Two EE
monitors are added on port 1 of the Encryption Switch, which is an F_Port that attaches to the
target device.
1. Get the CryptoTarget container configuration. This command shows the PIDs for the target, the
virtual target, the initiator, and the virtual initiator:
EncryptionSwitch:SecurityAdmin>cryptocfg --show -container -all -stat
Encryption group name: brcd
Number of Container(s): 1
Container name: st_target
Type: disk
EE node: 10:00:00:05:1e:53:b8:45
EE slot: 0
Target: 2f:ff:00:06:2b:0e:b3:3c 2f:ff:00:06:2b:0e:b3:3c
Target PID: 0a0100
VT: 20:00:00:05:1e:53:b8:41 20:00:00:05:1e:53:b8:41
VT PID: 0a2001
Number of host(s): 1
Number of rekey session(s): 0
Host: 10:00:00:00:c9:52:00:7d 20:00:00:00:c9:52:00:7d
Host PID: 01a000
VI: 20:01:00:05:1e:53:b8:41 20:02:00:05:1e:53:b8:41
VI PID: 0a2002
Number of LUN(s): 1
LUN number: 0x0
LUN type: disk
LUN serial number: 600062B0000EB33C00000000000000000000000000000000
Encryption mode: encrypt
Encryption format: native
Encrypt existing data: disabled
Rekey: disabled
LUN state: Encryption enabled
Encryption algorithm: AES256-XTS
Key ID state: Read write
Key ID: ba:26:50:3a:22:72:01:04:c9:57:ff:27:77:e3:8d:6d
Key creation time: Tue May 20 08:32:25 2008
Operation Succeeded
To Next Page
Loading...
