Fabric OS Command Reference 57
53-1001764-02
authUtil
2
To set the Device policy to passive mode:
switch:admin> authutil --policy -dev passive
Warning: Activating the authentication policy requires
DH-CHAP secrets on both switch and device. Otherwise,
the F-port will be disabled during next F-port
bring-up.
ARE YOU SURE (yes, y, no, n): [no] y
Device authentication is set to PASSIVE
To set the device authentication policy to “on” mode:
switch:admin> authutil --policy -dev on
Warning: Activating the authentication policy requires DH-CHAP secrets on both
switch and device. Otherwise, the F-port will be disabled during next F-port
bring-up.
ARE YOU SURE (yes, y, no, n): [no] y
Device authenticaiton is set to ON
2008/03/24-23:13:06, [AUTH-1003], 112,, INFO, Stealth_3, Device authentication
type has been successfully set to ON
To start authentication on E/F_Ports 2, 3, and 4:
switch:admin> authutil --authinit 2,3,4
To disable md5 hash type for FIPS configuration:
switch:admin> authutil --show
AUTH TYPE HASH TYPE GROUP TYPE
--------------------------------------
fcap,dhchap sha1,md5 1
Switch Authentication Policy: PASSIVE
Device Authentication Policy: OFF
switch:admin> authutil --set -h sha1
Hash is set to sha1.
switch:admin> authutil --show
AUTH TYPE HASH TYPE GROUP TYPE
--------------------------------------
fcap,dhchap sha1 1
Switch Authentication Policy: PASSIVE
Device Authentication Policy: OFF
See Also portShow, secAuthSecret
To Next Page
Loading...
