What to do if other procedures do not resolve the problem with Brocade Communications Systems Switch?
If other troubleshooting steps don't fix the issue with your Brocade Communications Systems Switch, try using a different port or a different cable to see if that resolves the problem.
How to check cabling of Brocade Communications Systems FastIron GS Switch?
To ensure a stable connection for your Brocade Communications Systems Switch, verify that both ends of the cabling (at the Brocade device and the connected device) are securely connected.
How to check if port is disabled on Brocade Communications Systems FastIron GS?
To determine if the port on your Brocade Communications Systems Switch has been disabled, use the CLI. If an IP address is configured, you can also use the Web management interface or IronView Network Manager.
What to do if MDI or MDIX change causes reflected pulse on Brocade Communications Systems FastIron GS?
In the case when the remote pair is set to forced 100 Mbps, any change in MDI or MDIX may cause the device to interpret the Multilevel Threshold-3 (MLT-3) as a reflected pulse. Brocade recommends that you run the TDR test a few times for accurate results with your Brocade Communications Systems Switch.
General| Model | FastIron GS |
|---|---|
| Rack Mountable | Yes |
| Form Factor | 1U |
| Layer | 2/3 |
| Power over Ethernet (PoE) | Available on some models |
| Management | Web-based, CLI, SNMP |
| VLAN Support | Yes |
| Layer 3 Routing | Static routing, RIP, OSPF |
| Memory | Varies by model |
| Operating Humidity | 10% to 90% non-condensing |
To Next Page
