Modified RIP commands TABLE 11
FastIron release 08.0.xx FastIron release 07.4.00 Note
Global-level command (router RIP and sub-command)
[no] redistribute connected |
bgp | ospf | static |metric value |
route-map name]
[no] redistribution Redistributes routes from other routing
protocols
[no] prefix-list name in | out filter filter-num permit | deny
source-ip-address | any source-
mask | any [log]
Specifies the prefix list as route map to
filter out specific routes
[no] timers seconds update-time 1-1000 Configures timer to set how often RIP
sends updates. This command is added
for backward compatibility.
Interface-level command
[no] ip rip metric-offset num in |
out
ip metric 1-16 ip metric is not supported. Since ip
metric was used to modify RIP metric, it is
changed to ip rip metric-offset. It is
added for backward compatibility only.
[no] ip rip prefix-list name in |
out
[no] ip rip filter-group in | out
filter-list
Specifies the prefix list as route map to
filter out specific routes.
Deprecated RIP commands TABLE 12
Command Note
Global-level command (router RIP and sub-command)
[no] offset-list ACL-number-or-name in | out offset
[ethernet port]
Instead, the route-map or prefix-list command
can be used.
[no] permit | deny redistribute filter-num all | bgp | ospf |
static address ip-addr ip-mask [match-metric value | set-
metric value]
Instead, the route-map command can be used.
[no] dont-advertise-connected Connected routes are not redistributed by default
in FastIron 08.0.xx.
BGP and Route-Map
Modified BGP commands TABLE 13
FastIron release 08.0.xx FastIron release 07.4.00 Note
Clear command
clear ip bgp flap-statistics clear ip bgp flap-statistics as-path-
filter list-num
The as-path-filter option is removed
because flap statistics no longer have the
as-path-filter option.
BGP and Route-Map
44 FastIron Ethernet Switch Software Upgrade Guide
53-1003632-02
To Next Page
Loading...
Need help?
General
