Brocade Communications Systems FastIron X Series Software Update

BGP parameter default values
Changes in BGP, BGP4+, and Route Maps defaults TABLE 4
Parameter FastIron 08.0.xx FastIron 07.4.00 Note
Maximum retry interval 160 N/A If an error occurs during the
establishment of BGP adjacency, the
retry interval would have exponential
backoff. The maximum delay can be
160 seconds.
Maximum route map length 81 32 Configures the maximum route map
length when configured through
SNMP (not configurable)
Default behavior for invalid
confederation AS path
Ignore Not ignored Not configurable
Minimal route advertisement
interval
0 30 Configurable
Maximum route advertisement
interval
3600 sec 600 sec Configurable
Update time 0 - 30 sec 1 - 30 sec Configures iBGP route update
interval.
Maximum ECMP paths in BGP 8/6 (stackable and TI/
others); 32 in FastIron
08.0.30
8 Configures the number of ECMP
paths
Minimum allowed update time 0 1 Not configurable
Routes displayed per page 13 5 Not configurable
Command changes
Several commands have been replaced or modified in FastIron 08.0.xx. Brocade recommends that you
use the new set of commands. The following sections summarize the differences in commands between
FastIron 07.4.00 and FastIron 08.0.xx.
OSPFv2
New OSPFv2 commands TABLE 5
Command Note
Global level command (router OSPF and sub-command)
[no] router ospf vrf Configures OSPF instance with VRF index
[no] default-passive-interface Sets OSPF interface passive
BGP parameter default values
FastIron Ethernet Switch Software Upgrade Guide 39
53-1003632-02

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English