Brocade Communications Systems ICX 7250 series User Manual

IPv6 management (IPv6 host support)
You can congure a FastIron X Series, FCX, or ICX switch to serve as an IPv6 host in an IPv6 network. An IPv6 host has IPv6 addresses
on its interfaces, but does not have full IPv6 routing enabled on it.
This section describes the IPv6 host features supported on FastIron X Series devices.
Conguring IPv6 management ACLs
When you enter the ipv6 access-list command, the Brocade device enters the IPv6 Access List conguration level, where you can
access several commands for conguring IPv6 ACL entries. After conguring the ACL entries, you can apply them to network
management access features such as Telnet, SSH, Web, and SNMP.
NOTE
Unlike IPv4, there is no distinction between standard and extended ACLs in IPv6.
FastIron(config)#ipv6 access-list netw
FastIron(config-ipv6-access-list-netw)#
Syntax: [no] ipv6 access-list ACL-name
The ACL-name variable species a name for the IPv6 ACL. An IPv6 ACL name cannot start with a numeral, for example, 1access. Also,
an IPv4 ACL and an IPv6 ACL cannot share the same name.
Restricting SNMP access to an IPv6 node
You can restrict SNMP access to the device to the IPv6 host whose IP address you specify. To do so, enter a command such as the
following.
device(config)#snmp-client ipv6 2001:DB8:89::23
Syntax: snmp-client ipv6 ipv6-address
The ipv6-address you specify must be in hexadecimal format using 16-bit values between colons as documented in RFC 2373.
Specifying an IPv6 SNMP trap receiver
You can specify an IPv6 host as a trap receiver to ensure that all SNMP traps sent by the device will go to the same SNMP trap receiver
or set of receivers, typically one or more host devices on the network. To do so, enter a command such as the following.
device(config)#snmp-server host ipv6 2001:DB8:89::13
Syntax: snmp-server host ipv6 ipv6-address
The ipv6-address you specify must be in hexadecimal format using 16-bit values between colons as documented in RFC 2373.
Conguring SNMP V3 over IPv6
Brocade FastIron X Series, FCX, and ICX devices support IPv6 for SNMP version 3. For more information about how to congure
SNMP, refer to FastIron Ethernet Switch Security Conguration Guide .
IPv6 management (IPv6 host support)
FastIron Ethernet Switch Layer 3 Routing
162 53-1003627-04

Brocade Communications Systems ICX 7250 series Specifications

General

Brand	Brocade Communications Systems
Model	ICX 7250 series
Category	Switch
Language	English