Brooks ATR60LF - Sensor Timeout and Serial Numbers; Signal Strength and Software (SIGNALSTRENGTH, SOFTREV, SoftwareRevisionLevel); Status and Test Configuration (STATUS_ENABLE, TARGETID, USETESTDIP)

Brooks Automation
260301 Revision A 51
ATR60LF RFID Reader CAN Bus 7 Operation
Product Manual 7.4 Attribute (ECID and SVID) Values
P - Pass
F - Failed
SENSOR_TIMEOUT Sensor delay after the trigger
Range 1 - 20
Unit 1 = 100 ms
Default: 01
SERIALNUM Serial number of the target device
Assigned at the factory and indicated on the label of the device, e.g.
1101MIS100001.
SerialNumber See  SERIALNUM
SIGNALSTRENGTH
(Read only)
Read only information RF signal strength (noise level!)
SW_PARTNUMBER Software part number
SOFTREV Subsystem software revision of Gateway or reader (head)
SoftwareRevision-
Level
See  SOFTREV
STATUS_ENABLE If set to Enable, Head communicates the STATUS information back to the
host.
EN = Enabled
DI = Disabled
Default: EN
TARGETID The TargetID of the device, adjustable through the DIP switches (see 
HeadID)
USETESTDIP Use DIP switches 6, 7 or 8 for test mode acitvities.
Unit Bit 0 - activity of DIP switch 8 (tuning)
Bit 1 - activity of DIP switch 7 (test mode)
Bit 2 - activity of DIP switch 6 (type of test)
Bit 4 - tuning only allowed in test mode
Range 0 - 15
Default: 7