2. Installation
User Manual Starting Up the P-102
7. Insert the cold probe in its the cold trap.
8. Make certain there are no sharp bends or strains on the flexible insulated line that leads to the cold
probe.
9. Check the vacuum chamber where the cryobaffle is installed for leaks between the vacuum
chamber and cryobaffle.
10. Rough the vacuum system down.
11. Turn on the P-102.
12. Be careful not to bend the insulated flex line much after the unit has chilled down the probe and
line. This can lead to cracks in the insulation.
NOTE: The system may be operating continuously. It should be turned off any time the fore- or
roughing pump(s) are to be turned off.
Accelerating Innovation 2-20
To Next Page
Loading...