EasyManuals Logo

Brother 1034D Manual

Brother 1034D
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Serger Badge: Brother 1034D
Age: Grade 9-Adult
LEVEL 2
Objectives:
To thread and sew a four-thread overlock stitch without supervision,
sew with three threads, and troubleshoot.
1. Thread the serger with no help.
2. Sew a four-thread overlock seam with no help.
3. Sewing with three threads
A. Rolled hem - used to finish edges of medium to light fabrics
1. Remove left needle
2. Change thread, if necessary, to match fabric
3. Thread machine for a three thread overlock, using the right needle
4. Remove the stitch finger (see diagram on p. 43 in manual)
a) Raise presser foot lever
b) Pull all threads toward back of machine
c) Make sure no thread is wrapped around stitch finger
d) Open front cover
e) Turn hand wheel until upperlooper is at its lowest position
f) Press the stitch finger release button to remove the stitch finger
g) Store the stitch finger in slot on the inside of the front cover (see
diagram on p. 43 in manual)
5. Adjust stitch width for rolled hemming - move stitch width lever to “R”
6. Adjust stitch length - move stitch length lever to “R”
7. Set tension dials - Lowerlooper tension should be tightened more than
upperlooper tension to “roll” the hem.
a) Upperlooper thread tension: 1-4
b) Lowerlooper thread tension: 5-7
c) Right needle thread tension: 4
d) Upperlooper and lowerlooper tensions will vary depending on
material.
8. Put your material under your presser foot, start the first few stitches with
the hand wheel, then serge your rolled hem.
9. Reminder: Replace stitch finger: push lever, match yellow arrows, and
push to left into the slot until secure, then release lever.

Other manuals for Brother 1034D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Brother 1034D and is the answer not in the manual?

Brother 1034D Specifications

General IconGeneral
TypeSerger
Number of Threads3 or 4
Stitch Length1.0mm to 4.0mm
Differential FeedYes
Differential Feed Ratio0.7 to 2.0
Maximum Sewing Speed1, 300 stitches per minute
Color-Coded ThreadingYes
Adjustable Stitch WidthYes
Free ArmYes
Thread TensionAdjustable
Presser Foot LifterYes
Built-in Thread CutterYes
Free Arm CapabilityYes
Power Requirements120V, 60Hz
Stitch Typesrolled hem
Stitch Width5.0mm - 7.0mm (overlock), 2.0mm (rolled hem)
NeedleStandard sewing machine needles (size 11 or 14)
Included Accessoriesgathering foot

Related product manuals