Brother 1034D - Page 9

Napkin Finish Rolled Edge (narrow)
Stitch narrow rolled edge
Right needle
4.0
Upper looper
5.0
Lower looper 7.0
Differential
0.07 - 0
Knife 3.0 - 5.0
Thread standard sewing
Removable
stitch finger
off
Fabric
lightweight woven
Stitch length R
Foot all purpose
Tablecloth Edging (wide)
Stitch
rolled edge wide
Left needle 4.0
Upper looper
5.0
Lower looper
7.0
Differential
0. 07 - 0
Knife 5.0 - 6.0
Thread standard sewing
Removable
stitch finger off
Fabric light to
heavyweight woven
~-
Stitch length R- 3
Foot all purpose
8
• Using the set up instructions at left, set your serger for rolled edge .
Check
your manual for information about removing the stitch finger .
• The set
up instructions reflect tensions using standard sewing thread.
You may have to adjust any tension setting for changes in thread type.
• Always allow your knife to shave the edge of your fabric creating an
even and consistent
fabric edge.
NOTE: Fabric
that has an uneven texture may not be successfully edged with
a narrow rolled hem .
• Some fabrics are
too heavy or too loosely woven to roll successfully using
the narrow rolled hem .
• Try
the set up at left and create a wide rolled hem .
•
If the fabric doesn't roll, lengthen the stitch. The longer the stitch, the
more able it is to roll a heavier fabric.
• This hem also gives a l
ittle more body to medium weight fabric.