Why does material peel off when inserting the Brother 891-Z02 mat?
If the attached material peels off when inserting the Brother Cutter mat, hold the mat level with your hands to compensate for the material's weight. If the mat's adhesive strength has decreased, replace it with a new one.
How to adjust line thickness on Brother 891-Z02?
If the drawn line is thicker or thinner than intended on your Brother Cutter, adjust the “Draw Speed” and “Draw Pressure” settings in the settings screen. Increase drawing pressure or reduce drawing speed for thicker lines; decrease drawing pressure or increase drawing speed for thinner lines. Perform a trial drawing after adjusting.
How to stop Brother 891-Z02 from scanning unwanted images?
If your Brother Cutter is scanning unwanted images, specify the paper size using the “Scan Size” setting in “Scan to USB” mode. In “Direct Cut” or “Scan to Cut Data” mode, trim the image in the editing screen after scanning.
How to fix lines in scanned images on Brother 891-Z02 Cutter?
If your Brother Cutter isn't scanning cleanly (lines in the scanned image), clean the scanner glass from the bottom of the machine. If the original is dirty or scratched, remove thin lines or dirt in the image editing screen in “Direct Cut” or “Scan to Cut Data” mode.
To Next Page
General
