Brother b837 - Reverse Switch Mechanism; [!]Reverse Mechanism

[!] REVERSE MECHANISM
Procedures
1. Install rear cover 0 with two screws 8.
Reverse switch cord
Thread wiper cord
Reverse solenoid
Termmal pm (black)
12-pm plug
Terminal
pin (white)
2. Set the reverse crank 0 fork on the reverse solenoid plunger 8.
3. Secure the reverse crank 0 to the solenoid base 8 with screw f).
4. Secure solenoid base 8 with screw f).
5. Secure reverse link 0 and reverse crank 0 with screw 0.
6. Secure the cords with the cord clamp Gi) and screws CD.
7. Install reverse solenoid cover f) with screw$.
8. Install terminal pin to the 12-pin plug.
Ill REVERSE ASSEMBLY ADJUSTMENT
1. Set the feed regulator dial to the maximum setting.
2. Loosen screw fD and raise the reverse soleno1d
plunger
G until 1t hits the back of the cylinder.
Pull the reverse handle 49 all the way down. and firmly
tighten the
set screw e.
-23-
From the library of: Superior Sewing Machine & Supply LLC