~.
[I]
STITCH LENGTH
ADJUSTMENT
f)__,_
__
_
-
@)=::r-------~~-~
1 . Forward feed adjustment
(1) Set the feed regulator dial 0 to the maximum position.
(2)
Sew.
(3) Measure the stitch length.
To increase stitch length
( 1 ) Loosen screw
8.
and turn the feed regulator dial 0 counterclockwise.
(2) Tighten screw
8.
and turn the feed regulator dial 0 clockwise.
To decrease stitch length
(
1)
Turn the feed regulator dial 0 all the way counterclockwise.
(2) Loosen screw
8.
and turn the feed regulator dial 0 clockwise.
(3) Tighten screw
8.
2.
Reverse feed sewing
*Reverse
feed stitch length
is
determined by the forward feed stitch length.
3.
Aligning forward/reverse feed stitch lengths
( 1 ) Adjust the forward feed stitch length.
(2) Sew. Stop the machine with the needle below the top of the needle plate.
(3)
Drop
the reverse lever 8 (reverse feed switch) all the way down to sew in reverse.
(4) Adjust the reverse feed stitch length by adjusting the position
of
the stopper 0 on the reverse lever
0.
Reverse feed
stitch length
will decrease
as
the stopper 0 is raised.
• Readjust the stopper 0 position when the forward feed stitch length
is
changed.
-35-
From the library of: Superior Sewing Machine & Supply LLC
To Next Page
