Brother b837 - Feed Dog Height Adjustment

•
[II FEED DOG HEIGHT ADJUSTMENT
0
7
1. Turn the pulley and set the feed dog 0 to the up position.
2. The feed dog 0 should be 1.0 mm above the needle plate. Loosen screw 8 and vertically adjust the feed bar 0 to
adjust the height.
11
The back of the feed dog needle hole should be smooth to enable free thread passage.
Frrmly tighen screw 8 after adjusting the height.
llllf the feed dog is too high: . . . • The feed dog will strrke the needle plate.
• Stitches will be longer than indicated by the feed regulator dial.
lll If the feed dog is too low: . . . . • Stitches will be shorter than indicated by the feed regulator dial.
-33-
From the library of: Superior Sewing Machine & Supply LLC