Sewing the Various Built-In Decorative Patterns 111
GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX
Checking the selected
pattern
Up to 70 patterns can be combined. If all of the
selected patterns cannot be displayed in the LCD at
the same time, the pattern can be checked according
to the following procedure.
1
Press (settings key) in the operation panel.
X The settings screen appears.
2
Press , , and (arrow keys) until
is selected.
3
Press (OK key).
X The screen for checking the pattern appears.
4
Press and to scroll through the
pattern and check it.
5
Press (OK key).
X The initial stitch screen appears again.
Changing the pattern length
The length of one part of a satin stitch can be set to
one of five sizes.
1
Select a satin stitch .
2
Press (settings key) in the operation panel.
X The settings screen appears.
3
Press , , and (arrow keys) until
is selected.
4
Press (OK key).
X The screen for changing the length of a satin
stitch appears.
5
Press and until the desired ratio is
selected.
The length can be set within the range of
and .
X The satin stitch length is changed.
6
Press (OK key).
X The initial stitch screen appears again.
S3_brotherE.book Page 111 Thursday, May 15, 2003 1:58 PM
To Next Page
Loading...
