Brother CS-8150 - Changing the Needle Stop Position; Adjusting the Brightness of the LCD

GETTING READY ———————————————————————————————————————————————————————
—
16
GETTING READYCONTENTS SEWING BASICS UTILITY STITCHES APPENDIX INDEX
Changing the needle stop
position
When the sewing machine is purchased, it is set to
leave the needle lowered in the fabric when sewing
is stopped. However, the machine can be set to
instead leave the needle raised when sewing is
stopped.
1
Press (settings key) in the operation
panel, and then press , , and
(arrow keys) until is selected.
2
Press (OK key).
X The screen for changing the needle stop
position appears.
3
Press to select .
To return to , press .
X The machine is now set to stop with the
needle in the raised position.
4
Press (OK key).
X The initial stitch screen appears again.
Adjusting the brightness of
the LCD
The brightness of the LCD can be adjusted.
1
Press (settings key) in the operation
panel, and then press , , and
(arrow keys) until is selected.
2
Press (OK key).
X The screen for changing the brightness of
the LCD appears.
3
To make the LCD brighter, press (–). To
make the LCD darker, press (+).
X The brightness of the LCD is changed.
4
Press (OK key).
X The initial stitch screen appears again.
S3_brotherE.book Page 16 Thursday, May 15, 2003 1:58 PM